![]() So if this is the case (and I presume what was causing other error) is this how it should be or should I change a setting somewhere? I’m just trying to do the old test a bunch of squares for different powers and speeds and what not. I tried lowering the speed and anything below 190mm/sec seems to work without that issue. I presume may be too fast to be that close to edge. I am engraving powder coated metal water bottles, using LightBurn software and I ran a bunch of tests on one to trail and error the settings. I have the square at 9000 mm/s speed and 90 power fill. Androow (Andrew Korcek) March 10, 2021, 7:21pm 1 I have the 20w ortur master 2, I bought the 20w one because I figured it would be the best of the 3 options. ![]() (Right-click the 'Devices' button to reset the connection) G-code motion target exceeds machine travel. ![]() When I create new file and simple it down to one square and in corner I get this when I hit continue anyway it does not actually cut anything just gives this. So is this perhaps part of the issue? I had 4 different little squares down there I had and was not working.
0 Comments
Leave a Reply. |